A place for all those ribbons! I got all the pieces at Hobby Lobby, an unfinished board with serpentine top and grooves already cut in, the decorative piece glued on top, and the knobs. The vinyl I had a friend cut for me, the paint, stain, hacksaw and picture hanger I already had.
1) stain the board and decorative piece
2) paint both pieces and distress using fine sandpaper
3) use wood glue to attach the decorative piece
4) evenly space your knobs and mark where you want to drill the holes with a pencil
5) drill holes just a little smaller than the screws on the knobs
6) turn the piece over. Using a drill bit that is a little bigger than the nut, center over your first drilled hole and drill into the back of the board a small ways
7) screw in the knobs and tighten the nuts. If you screw from the front you will get them tighter.
8) use a hacksaw to cut the extra length off (or you can measure them and cut first.)
9) File the ends of the bolts if necessary
10) add a picture hanger
